Simson

joke-mode on Pete, next time you better only sell the manual and 14 days later people get the tool for free. I'm one of those people who deserved it this way too... joke-mode off

Hi, i found this old thread because i'm also trying to set the explained multiaxis.lua to my Hotas Warthog's x-axis so i can switch between aileron and rudder function. First of all, i'm running P3Dv3, latest registered FSUIPC version, a default plane in this case. I already generated the multiaxis.lua in the modules folder as well as added the [AUTO] section to the fsuipc.ini and so on. Axis and buttons in P3D controls are deleted and controls disabled. I only use fsuipc calibration and button assignements. LINDA is installed and running but not used at the moment. Just for your information. Don't know if it might cause problems? So i think i did setup everything correctly as described in this thread, I have assigned the "LuaValue Multiaxis" to my x axis and "sent to FS as normal axis" checked. In the "button and switches" tab i have assigned button 14 and 16 each with "offset dword set" and "x66C0" and one button with parameter 64101 (but it shows x0000FA65 which i think is correct) and the other button with 64103 (it shows then x0000FA67 in the parameter field). Problem is after enabling a function (button) in P3D i can not calibrate aileron or rudder in fsuipc. The x axis seems not to be recognised anymore. Anyone with a possible solution to solve this issue? Thanks, Simson