Sparky7

Hi Pete, Many thanks for the prompt reply and solution!. I re-installed as suggested and approved the dlls inclusion at start up... FSX ran ok. Subsequent re-starts have not shown a recurrence of the error message. Paul

I am new to this forum having recently purchased a full licenced version of FSUIPC4 version 4.972. I am currently running FSX SE with a CH throttle quadrant and a Black Widow XE joystick. My hardware platform is a DELL XPS 8920 64 bit machine running windows 10. Hopefully the fault description, and the supporting info supplied, conform to Pete Dowson’s helpful guide on problem reporting so here goes… Any thoughts or suggestions would be most helpful J Problem description: FSUIPC4 installed in trial mode and worked fine in FSX-SE, I re-installed having purchased a licence key, the install was successful and again FSX-SE worked correctly and displayed the options menu and the fully tabbed interface. So far so good… then at some point FSX SE crashed (probably following a period when the machine was in sleep mode) but before I had set up any control axis, buttons, etc. The next time I ran FSX-SE it complained that it didn’t like the FSUIPC4.dll and gave me the option to run the FSX with and without the FSUIPC software. Running without allows FSX SE to run normally, running with it now causes FSX SE to hang and then close. Problem data logs: The associated windows application report shows an app crash. See attached file. Also seen is a windows application report citing a SidebySide error. See attached file. I have not been able to find the FSUIPC.log or FSUIPC4.log I suspect these have not been created since I never got as far programming up the CH throttle etc. The DLL.xml is attached The Install FSUIPC4.log file is attached dll.xml FSUIPC4 Install.log Windows app crash report.txt Windows SidebySide error report.txt