mamock

Thanks for replying so quickly Pete, I am following "Configuring FSUIPC with the CH USB Yoke, Rudder Pedals and Throttle Quadrant". version 1.10 by John Cook - But for 4 engine jet. 1. Separate CH Quadrant Levers - 1 per throttle with it's own reverse zone is the aim. 2. I have assigned the 4 middle levers on the CH Throttle Quadrant as engines 1-4. 3. When I go to calibration I get the same numbers (Max 16383 Fully forward / Min -16384 Fully back) for all levers, and can set a top idle as John Cook advises but when I set the lever into the reverse area (behind detent) the number is still -16383 as if this area is not being read at all. The detent back to fully back reads the same -16383. 4. If I set the idle zone by pushing the lever forward from the detent to get a top idle number set and a bottom idle number set when I go into FSX the reverse is showing as active but forward of idle. 5. FSUIPC Version 4.742 Hope this clarifies some. Regards, Mike

Hi Peter, I am trying to set reverse thrust with 4 engines in FSX with CHTQ using fsuipc. I have cleared out the AXIS in FSX and am failing miserably to set up the reverse thrust with fsuipc. I can set the max (16383) and min (-16384) but am not able to set reverser to function in the correct place ( behind idle). When I set the idle zone and do get the reverse to work it is always on when I have the TQ set at detent (idle position) or forward of this or doesn't work at all. I have tried to closely follow suggested guides but cannot make this Reverse work. Question: When I move the lever to max I get 16383, when I move the lever to fully back I get -16384, when I move the lever forward to detent(idle) the number stays the same - is this correct? Regards, Mike Win7 Latest FSUIPC FSX