Tatankamani

Thank you very much, I am going to try it. Bruno

Hi, I am running MSFS with FSUIPC7 (registered). I need help with programming Elevator Trim to a button. I refer to user manual page 25 and tried different parameters as i.e. 256/16383, 512/16383, 1024/16383 but I did not notice any change in trim characteristics. I own a (bad) "Flightvelocity" trim wheel which sends button keypresses instead of axis data and I want to make trimming a bit more efficient than it is per default. Thank you Bruno

Hi John, thank you for your additional advice on the missing step. I did not select the checkbox "Axis Elev. Trim Set" . Trim Wheel is working now with default setting "send to FS as normal Axis". I am going to purchase a registered copy of FSUIPC7. Thank you again Bruno

Thank you; I try it again. But it will take one or two days. I am having problems with my PC and need to figure out where do it come from. I am back, as soon FS is running again.

1) Here are the requested files. 2) I have sent data direct to FSUIPC calibration. But in menu Joystick calibration - Elevator trim, none of displayed figures did change when turning the wheel. Btw. I know this function from FSUIPC4. Additionally I did the same with my Yoke, which is working fine in MSFS. Calibration figures did not change either, when moving the Yoke. FSUIPC7.ini FSUIPC7.log

Thank you for your advise. I am not sure if I will be able to give feedback on 26th, but I will be back on 27th.

Thank you John for providing the key, but I had no success so far. Here is what I did: - Start FSUIPC with Alt+F - Axis Assignment - Rescan - rotate Trim Wheel - Trim Wheel immediately identified; IN and OUT numbers are changing with wheel movment - send to FS as normal Axis - made a Testflight But Trim Wheel does not affect flight behaviour, as it was without FSUIPC. Any idea what else I could try ? Bruno

Hi John, thank you for offering a time limited license of FSUIPC. Yes, I would like to try it. How can we continue ? Thank you Bruno

Hi, my old Saitek Trim Wheel is not working in MSFS. Strangly, the Trim Wheel is being identified by MSFS correctly and can be calibrated as other hardware (Saitek Yoke). But turning the Trim Wheel in flight does not affect the behaviour of the aircraft at all. My question now is, will I get the Saitek Trim Wheel working with registered version of FSUIPC7 ? Thank you Bruno