Help with Rotary

[coolcatkelso]

Hi Guys

 

I have successfully built a little control panel with Toggle Switches using a cheap board I found on ebay: This is the board http://www.ebay.co.uk/itm/2x-Zero-Delay-Arcade-USB-Encoder-PC-to-Joystick-For-2pin-Happ-Type-Push-buttons-/171137341154?pt=LH_DefaultDomain_0&hash=item27d89496e2#ht_6220wt_905

I have also bought a few Rotary Encoder 5 Pins (pushbuttons) and 1x 2P6T 2Pole 6Position 1 Deck 14P Rotary Switch w Knob

I have all my lights wired up to the Toggle Switches, works perfectly

What I would like to do now with the remaining rotarys is :

1x Rotary for Comm1 Up and Down (the switch is 360 degrees)

And the 6 Position dial to control the autobrake

I have these available ports left on the usb cards

 

Up Axis, Down Axis, Left Axis & Right Axis (I have 2 of these boards, so double the axis again)

and for Buttons I have 4 on each so total of 8 buttons avilable

Can someone help me figure out what I need to do?