brakes calibration

[fersini86]

hello,

 

i have a problem with a brake calibration;

 

i have dual linked rudder connected on a Leo Bodnar card;

 

i open the windows calibration system, i make all the steps for the rudder ,left and right brake, i end the calibration and on the test page ,the 3 axis move very well.

 

i enter in FSUIPC and i want to assign the 3 axis ,all works good for the rudder and the right brake but i have a problem with left brake,i explain:

 

when i push on the left brake i can see a value of 16383 but when i release the brake i have 14236 instead of -16383.

 

i don't understand ,

[Pete Dowson]

when i push on the left brake i can see a value of 16383 but when i release the brake i have 14236 instead of -16383.

 

i don't understand ,

 

Where do you see these values? If those are the "OUT" values then you have not calibrated that left brake axis.

 

Pete

[fersini86]

hello Pete 

 

we are very busy because we are working hard to open our simcenter as soon as possible,in this case i'll make some print screen in a few days to explain more precisely,

 

thank you for your assistance,

 

you can take a look to our project : https://mfssimcenter.com/

 

regards,