Stab trim with FSUIPC

[D4n539]

Hello,

I want to configure with my trottle panel the 2 Stab trim (main elec, auto pilot) with 737ngx PMDG.

What the action to configure this switch in FSUIPC ?

Thank you for you answers.

[Pete Dowson]

I want to configure with my trottle panel the 2 Stab trim (main elec, auto pilot) with 737ngx PMDG.

What the action to configure this switch in FSUIPC ?

Thank you for you answers.

 

Apologies for the delay. As you will have seen, I have been away on holiday.

 

Do you mean elevator trim? Why "2"? What action do you use in the NGX?

 

Pete

[D4n539]

When I say "Stab trim" I speak about this: http://www.flaps2approach.com/journal/2013/4/19/replacement-genuine-737-throttle-center-pedestal-full-conver.html

If a fonction to assign an action for this buttons exist in FSUIPC, tell me.

Thank you for your answer.

[Pete Dowson]

When I say "Stab trim" I speak about this: http://www.flaps2approach.com/journal/2013/4/19/replacement-genuine-737-throttle-center-pedestal-full-conver.html

If a fonction to assign an action for this buttons exist in FSUIPC, tell me.

 

Ah, you mean the Stab Trim cut-out / override switches.  Stab trim is the actual elevator trim operated by the wheels or the buttons on the yoke.

 

Those aren't supported by FS itself, but they should be supported by the PMDG 737NGX, probably with extra control numbers. You'd need to find the correct control numbers in the 737NGX SDK document (the one of filetype .h) and assign in FSUIPC using the <custom control> assignment, which allows you to enter non-FS control numbers.

 

Pete