Jump to content
The simFlight Network Forums

Some Saitek axes only provide partial movement


Pete Dowson

Recommended Posts

This is from a typical post I receive in the Support forum, complaining about one or more of the axes on Saitek throttle quadrants:

 

"... looking into fsuipc, i noticed, that the max value 16383 was reached on the most right lever way before it should have."

 

This appears to be a common Saitek problem, and I think it is usually easily dealt with by some registry editing 

 

Thanks to a contribution by Al ("Ark1320") I can now provide more explicit help. The details which used to be found here on the Saitek website are shown below:

 

Hope this helps, and thanks Al.

 

Pete

 

------------------------------------------------------------------------------------

 

From Saitek:

 

 If you are finding that the axes on your controller are not travelling through their full range of movement and/or are not centering correctly then try these fixes. The first fix deals specifically with Flight Sim. The second fix deals directly with the controller in Windows and should resolve any issues detected in Control Panel > Game Controllers > Properties.

1.  If you are having trouble with calibration in Flight Sim then you might need to rebuild the config (cfg) file.

To rebuild the Flight Simulator config file, press and hold down CTRL+SHIFT as you start Flight Simulator and start a new flight. Continue to hold down CTRL+SHIFT until the game is in Cockpit view.

 Note - When you rebuild the config file, some of your joystick settings may    change.

This should work for FS9 and FSX. Once you have got in to the cockpit - make sure you move the controller in the full range of all its axes 4 times to make sure the calibration data is recorded properly.

2.      To recalibrate in Windows, first remove the USB plug for your controller from the PC.

Press and hold the Windows key on your keyboard and then press the letter R. This will open the Run box. Type regedit and then click ok.

         The Registry Editor will have a list of folders on the left hand side. Go down into the     following folders in order by clicking the + next to the folder name.

         +HKEY_LOCAL_MACHINE (CURRENT_USER if on Vista)
+System
+CurrentControlSet
+Control
+Media Properties
+Private Properties
+Direct Input (Note: Direct Input does
exist
in Win7), don’t be “fooled” by Joystick\OEM

Delete any folder inside the Direct Input folder that begins VID_06A3.  Clicking on VID_06A3 entries should show some Saitek info.  

Once deleted, close the editor, then plug the USB back into the original port. Move all the axes of the controller through their full range of movement four times.

Now go to Control Panel > Game Controllers > Properties to check the axes on the test screen. If the issue persists then test the controller on another PC to see if the issue is replicated.

If it is replicated then it is most likely a fault with the controller which will need to be replaced if it is still within warranty.

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.