LuxRalf

When I'm DISable FSUIPC all is OK. So: no broken wire or other strange things. I wil contact the CH forum. When it's nothing with your software?! OK Bye Ralf

With my USB power management is all OK. The BIG problem is the elevator! When I'm flying it's possible that the elevator is suddenly falling in full down position. That's NOT funny :sad: Also the throttle and rudder: When I start P3D the throttle is full on and I have to give some thrust and then immediately back to idle; the rudder is directly after the P3D start in full left position. So I am driving around with full thrust if I'm not careful. Regards Ralf

Hi Pete I'm using FSUIPC v4.853, Prepar3d 1.4 and Windows 7 Ultimate 64 bit. I was flying 30 minutes before a little bit VFR. The problem appears only immediately after startup of P3D. After a little rudder, breakes and throttle movement. It's all OK. The stick, yoke and pedals are calibrated in the CH Control Manager, NOT in FSUIPC. Regards Ralf

Hi I have the Fighterstick and the Eclipse yoke from CH Products. When I am starting P3D the throttle is always full on and the elevator is in full down position. After a small movement of the throttle it is all OK. Also with the elevator. The elevator sometimes behaves strangely. When I pull the stick back, the elevator suddenly falls from the upper to the lower position. And when I restart P3D, sometimes its all OK, sometimes not. Is this a problem from CH Products or from the settings in P3D? Or is it a problem in interaction of all? Or only a configuration problem of FSUIPC? Ralf