imhotep747
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by imhotep747
-
-
Hi everyone,
I've just connect a yoke through my Client PC and when I open FSUIPC in the server PC, on the "Buttons + Switches" I can see it recognized the action when I click ie, Elev Trim Up.
I would like to know if it suppose to works as well for the Aileron or Elevator Axis Assignment because nothing happened when I move any axe.
FSUIPC ver3.999z9b on FS9
Thanks
-
Hello folks
Some of you might smile, and you must.
When you stuck on a problem sometimes you missed the simple solution.
I set up two PC:
PC1 AMD Q10 Quad Core 3.4Ghz RAM 8Go (no graphic card) -----------FS9 for Instruments and gauges------- 3 monitors
PC2 AMD Q10 Quad Core 3.8Ghz RAM 8Go Nvidia GTX780 3Go TripleHead2go (2x) ------------ 6 monitors
The question is why is that some airport are not well aligned?
Even after reinstallation.Thank you for your help
-
Hello,
I don't know if this post is close and if Les Parson solve his problem.
I use two Matrox TripleHead2go with Nvidia GTX780 3Go it give you
no less than 6 screens each monitor is a 22" Lenovo. It suppose to
run smoodly since FS9 is an old software but I have some issues.On the second hand, Wideview works find with no problem at all.
All the best
Remote throttle
in FSUIPC Support Pete Dowson Modules
Posted
Thank you Pete
You're right I didn't think about the delay response.