peter hall

John MATE ! You gave me some ideas as to why it was working in P3D but not in FSX so i went back into the Menu and while there ,FSX crashed and had to shut down , so i rebooted and calibrated etc and PRESTO the QUADRANT has come back to proper operation on its own accord somehow ? Thanks for your PROMPT response again mate and I'm happy again . Cheers , Peter .H.!

John , i had a shot using FSUIPC4 for FSX and found as expected with my SAITEK QUADRANT. The X/THROTTLE AXIS goes from 0 straight to 16383 with nothing inbetween as soon as i move it off the detent ? The Y/PROP AXIS is showing numbers smoothly but with limited travel ? And the Z/AXIS has no probs with smooth numbers and full travel ? The calibration was the same ? No probs in P3D V4.5 /only FSX . It looks like a DRIVER prob ? Do you think SPAD would fix it ? Thanks Regards Peter.H !

Thanks again John CHEERS mate ! stay safe in these dangerous times .

John another question please mate .I have FSX with a SAITEK Quadrant and want to use FSUIPC4 to get it working properly with the Throttle/Prop/Mixture Axis or X/Y/Z , Z axis is fine but i am not getting full travel with X/Y and from about 30% its all or nothing showing in the sim with the slightest touch on the Quadrant doing this ? , so i am hoping FSUIPC will fix it ? Do i need to Disable just my X/Y/Z Axis in FSX to use the FSUIPC or do i have do Disable all the switches too ? I have the SAITEK YOKE/RUDDER PEDALS/ CESSNA TRIM WHEEL/ and of course the Quadrant! Its a strange one because i have no problems at all with the Quadrant in P3D V4.5 ? P.S. do i need the Makerunways too as i see there is already one in the P3D V4.5 folder ? Your help is much appreciated Mate ! Regards Peter.H.

Thanks for the prompt response John and will get V5 Registered version to put into my P3D V4.5 , and i nearly forgot do i need to install your makerunways too as i notice that P3D V4.5 already list's it in the folder ? Thanks again Regards Peter.H !

Hi Pete , i have an older version 4.996 which was used mainly on FSX Windows 7/64 . I also have P3D V4.5 but apart from makerunways it did not install into that . I have just upgraded to Windows 10/64 and want to run a few atc programs i have - RADAR CONTACT/PFE/and PRO ATC in P3D V4.5 .Do i just download your latest version , and where do i install it as i read in the Forums not to put it into the default programs folder which is where P3D is ? I like to use RADAR CONTACT mainly but read i will need your V5 to do this ? Thanks Mate. Regards Peter.H .