MatthewSchoenberg

I am attempting to start Wide Client automatically on start up of the computer. I put the file in the start up menu and it starts but it does not always connect properly to Wide Server. Is this the correct way to do this? Is there any reasaon it would start but not communicate properly with Wide Server? I am also starting Wide Client with various Project Magenta software modules. Since they are starting at the same time could this be affecting how Wide Client initially connects to Wide Server? Your help is appreciated. Reards, Matthew

Hi, Are you saying it is OK to use 6.712 client with 6.71 server? Matthew

Done and works perfectly. Thank you!

The problem I seem to be having now is that I can not get the throttle to the lowest idle point without reversing the engines. Any help would be appreciated. I am starting to run out of ideas. :( Thanks, Matthew

I have tested this and have found that the ThrottleN set does not work in my set up but theThrottleN cut works perfectly. I am however having trouble with adjusting the trottles? I can not get the throttles to be fully idle and in the down position. Also, when they are moved toward the top of the range the reverse thrusters start. I am not clear as to what the range and center settings should be? I have read the manual but it seems a bit unclear to me. I am sure I am just missing something so a little help would be appreciated. Matthew

I think it will be "ThrottleN cut" -- try it. You can program that on the button release. If not that then just use "ThrottleN set" with a parameter of 0. Regards, Pete Hi, Has anyone determined which is better, ThrottleN cut or ThrottleN set with a parameter of 0? Many thanks, Matthew