Jump to content
The simFlight Network Forums

Bob Spinner

Members
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Bob Spinner

  • Rank
    Newbie

Profile Information

  • Gender
    Male
  • Location
    Scotland

Recent Profile Visitors

204 profile views
  1. First , thanks for such a speedy reply, if only everything in life could be as good. Secondly, my apologies for not posting in the correct place. Just so I don't get it wrong in the future where should it have been? Bob
  2. I have searched all the documentation that downloads with versions 4. 5, 6 and 7 of FSUIPC but nowhere can I find the offsets for the rudder and aileron trims. The offset for elevator trim and in conjunction with 'trim set' works a treat. Without the offsets for the rudder and aileron trims the 'trim set' command works just once and that's it. I am in no way a programmer but I am a bit of a dinosaur and so any help in simple English would be very much appreciated. Stay safe Bob
  3. Hi Roman, John. Thanks so much it works a treat. I would never have found a solution via the 'Buttons and Switches' menu interface. The only time that I dabbled with programming was to write a simple maths tutorial in Sinclair BASIC for a ZX Spectrum (that dates me). Now I can get back to setting up the rest of the panel. Thanks again Bob
  4. Hi John Attached is what I hope is a copy of the correct file. I am beginning to think that people are going to have to have the patience of a saint while leading me through my forays into FSUIPC. ********* FSUIPC5, Version 5.152 (24th July 2019) by Pete Dowson ********* User Name="Bob Spinner" User Addr="g1950536@btinternet.com" FSUIPC5 Key is provided WIDEFS7 not user registered, or expired 1265265 System time = 20/08/2019 15:11:33, Simulator time = 15:52:33 (19:52Z) 1265265 FLT path = "C:\Users\Bob\Documents\Prepar3D v4 Files\" [Continuation log requested by user
  5. As a first post I hope that I am using the correct part of the forum. I am using P3D v 4.5.12.30293 with FSUIPC v5.151. A while ago I built a panel to go along with my Saitek radio and multi panel. It was a modest affair as I am not an electronics or programming buff. It consisted of switches, rotary encoders and a 4 position rotary switch to enhance my single engine Cessna immersion. These were all connected to a Leo Bodnar BU0836X and BBI-32 boards. All worked fine. Despite my age my simming experience is of newbie standard but I look to the future. That being the case I decided
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.