ksnarf

i got my drivers from this site http://www.schiratti.com/dowson.html I have this: FSUIPC 3.65 This is an entirely new copy of FS, because i didn't want anything i did on my old version to conflict. I will zero out all controls again and setup for twin prop and stop the config.ini as you requested. thanks for the help, I do appreciate it.

I am using the latest version as downloaded from your website last night here is the additional information i have found. I used three aircraft for this test. the Flight 1 Cessna 421c the MS Lear the MS Baron all axis are programmed through FSUIPC only, including all buttons on my various control units. sensitivies have been set and verified. I deleted all axis assignments and loaded up the Cessna 421c I set up everything for a twin prop and flew a short patten to verify the assingments. I then loaded up the Default lear. right away the mixture stopped working. I went into assignments and set my prop levers as reverser's. both my prop's and Mixture 1 levers worked as reverser's. I set my mixture to reverse and my props to nothing i then took a short pattern flight in the lear to verify my settings. please keep in mind i made the changes regarding the reverser's as aircraft specific and did not change anything else then i loaded up the default baron and used the default config which had my mixture levers as mixture and they did not move in the aircraft. I have verified as much as a can, please help. -kris

I have searched the forum with out success, so Sorry if this has already been covered. I have used Peter's Dowson's modules for a couple years and was quite happy to support him when he made a pay version here is the issue i am having. if i setup all my axis (CH yoke, rudder and throttle quad) it works fine, but if i start to play with the Aircraft specific settings, my mixture controls (my quad is setup for a twin prop) stop working completly. they will be reconized when goto assign axis, but not when i try and calabrate it in the next tab. I have tried everything with no avial. i really like the aircraft specific option, as i turn my prop levers into reverse levers for jet aircraft and it makes it alot easier. again, no matter what i do Mixture 1 and 2 will no be seen. if i add mixture 3 and 4 to those axis, it will show up, but not 1 or 2. thanks.