carm

Never mind, I located them. :oops:

I had them, But now I cannot find the Manuals for my E 170 and 190. Where do I start looking ? :???: Thanks, CJ.

Thank you men What you suggested was the answer Ian. My throttles etc now work as they should. Cheers Carm.

I'm using a CH Quadrant. I have no problem assigning and calibrating #3&4. But 1&2 will not cooperate. I cannot get an Idle position on them. They won't go lower that about 30 or 40 % position, also when advanced to Full they advance in segments. I can get a Reverse position on them. I have used the FSUIPC for some time----no problems. But not now. I have tried everything I know of, even reinstalling the Fsuipc. Help !!

I can't find an answer to my questions--so here we go. How can I adjust my throttles so that their response begins at the start of the throttle movement, now they only cause the engines to respond when they are about 3/4 open. Also, how do I set the FSUIPC to cut jet engines from an idle. Thanks for any help.

Ian, you are right on. That is exactly what I did not do.--name " exactly as sent". All is okay now. Another example of ----when all else fails- read the Manual. Thanks

I have purched a registration Key from Sim market, but be darned if it will work. Keeps telling me it's invalid. I have FSUIPC 3.98 on my Fs9 Sim. The Product from Sim Market is -- 1x Pete Dowson - Fsuipc 3. [as per the invoice]. Is this the correct key download for what I have in my FS 9 ? Thanks for any help.

Thank you for the prompt and helpful reply; I now believe that my problem was sloppiness, on my part. I checked you suggestions,and discovered that I had not been assigning" direct to FSUIPC"--- which I had been doing in the past. When I resetup my Quad and assigned as per your instructions, the problem is gone. I just checked on the Lancaster and its fine now . Thanks for the help. :)

I have a registered Fsuipc installed and am using it with a CH Quad in FSX. I just recently developed a problem. When I reverte back to my straight CH Yolk. It seems that an Axis used with the Quad is affecting a yoke function Ie - When the yoke throttles are opened to full, if the yoke aerleron is moved, the port engine goes to idle. This can be eliminated by ' restoring ' the system. Some times the problem is when the throttles on the yoke are opened, at full throttle an engines RPMs wil go to Zero. Sure is frustrating, otherwise I am happy with the FSUIPC. I sure could use some help. :)