Sorry for double posting but when i try and calibrate my joystick it doesn't save what i have done and i need to start from scratch all over again. You can imagine how annoying this is. Especially when you have calibrated everything, start a flight, and then Elevator doesn't work. Seriously, what's going on with this? Elevator is completely dead EVERYTHING ELSE IS FINE! The Aircraft recognises Full Left Aileron, Full Right Aileron, Full Left Rudder, Full Right Rudder, Elevator UP nah lets not do that, Elevator down,sorry nope i don't want to work for you. Why is the Aerosoft Airbus recognising my Aileron, Rudder and not my Elevator? This is what i want to get to the bottom off. In FSUPIC for Elevator do i calibrate it as Elevator or Elevator Trim? Whats the difference. What i have tried to do so far is Calibrate it a Elevator and not Elevator Trim. I apologise if i seem angry i am at my wits end with this and it is very frustrating, especially when the calibration doesn't save after i have done it.
When i load up a flight at the default airport in P3D it works fine, it reconizes everything, but if i load a flight at say Edinburgh it only reconizes Aleron and Rudder I HAVEN'T DONE ANYTHING ELSE TO CHANGE THIS! Seriously, whats going on with this? #
I have attached my FSUPIC files previously but it doesn't seem too amount to anything.
I made the post on the aerosoft forums and as I said they directed me here https://forum.aerosoft.com/index.php?/topic/159948-aerosoft-a319-flight-control-problems-in-p3d-v4/&tab=comments#comment-1017928
Honestly i am at my wits end with all this. All i want to know is how to save what I have done so that when i start a flight my calibration is recognised. All i want is to get my elevators working, this is all i am asking for, everything else is fine. I apologise if i seem angry, i am, i don't mean to seem ungreatful for any support or anything this is just extremely frustrating when everything else IS FINE!