Jump to content
The simFlight Network Forums

byron

Members
  • Posts

    6
  • Joined

  • Last visited

About byron

  • Birthday 01/01/1970

Contact Methods

  • Website URL
    http://

byron's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Thank you very much. :D I use the pause key .... and FSInterrogate and Windows Paint and zoom :D :D :D I was getting fool with this indicator. Thanks again.
  2. Hi. Thanks for your answer. But I can't read the rigth value. That is: - Using FS-Interrogate I read: $3850: value 2007 $2038: value 0 And the Flight Simulator TIT indicator I read about 15.8 How must I convert $3850 value to FS value? Thanks.
  3. Hello. I'm having problems to locate the next value of Mooney Bravo: - ITT (interstage turbine temperature), that is shown as TIT Fx100 on engine panel (left-bottom). I try with offset $2038 and $3850, but I can't see the same value as indicated on FS panel. - Amperimeter (It is positioned right-up, with tank fuel). I have another question about IAS indicator. It has a white indicator that we can move. I think it's the barber pole to see TAS, but I'm not sure, because I move it but offset 02C4 don't change. Thanks.
  4. Hi. Thanks. I've found the problem. I was formating hex value wrong. Thank you very much.
  5. Hi. Yes. I'm using FS-Interrogate to confirm my reads, and it reads same as me. For example, altitude indicator on FS say about 1700 feet. I read $0570, 8 bytes, and I take 4 higher bytes, and then, I do Value/0.3048 to convert metres to feet, and the result is 121 feet and not 1700 I'm expecting. If I go to other altitude, for examplo 1434 feet, this operations gives me the correct value, 1434, compared to FS Cessna altitude indicator. The same happen about 900 feet. And the same happen with IAS and TAS. I'm using Delphi debugger and windows calculator to do the operation manually, and I see that fsuipc don't give me the correct value. thanks.
  6. Hi. I'm using fsuipc 3.70 and Delphi SDK. I've written an application to read some FS offset to show it into my application, but I've some problems: - Heading (offset $0580): I can't read a right value. I read 4 bytes, and then I apply the next operation: ( value read * 360 ) / (65536*65536). But I don't see the rigth heading. Where is it? - With some offset (for example, altitude), sometimes, it gives me wrong values. As I see, when I fly with Cessna about 800 - 900 feet, altitude read 60-80 feet. When I arrive 900 feet and up, then I read right altitude. It happens me with IAS to (about 90 nudes it read 6 nudes). What happen? Thanks.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.