Boeing Skunk Works

Thanks. That's just what I needed.

After looking around manually for this file and then performing a search for any .INI file, my computer doesn't find this file I see people talking about. Where is this file located? I would like to have a look at it out of curiosity. I'm running FS9 with the latest FSUIPC release for that version of FS.

I built the throttle and the pedestal. The installed equipment is Gables and Collins. It was quite a challenge to build from scratch. Thanks for your help Pete. Merry Christmas!

I found the problem. After re-reading the manual for the umpteenth time, I discovered my sensitivity setting for the Yr axis was not set correctly. All is well. I about peed my pants the first time the flaps came down from my throttle quadrant on a test flight. Every gate works perfectly! You are a genius for writing this software! Thanks!

Thank you for your reply. I am using FS9 and 1.01 version of the BI MM2. I will try what you suggest first. I was setting the first position and then setting the down position in the far right column, and then trying to add the increments in the middle. If I understand you correctly, the second position is the full down position until the flap gate increments are added between the two.

I've recently finished building a 727 throttle quadrant for my sim. I'm using Beta Innovations Plasma MM2 and a registered copy of FSUIPC. Calibrating the individual throttles was succesful, but I am having a problem with the flap detents. When trying to set up the gate positions following the instructions, the axis values do not display as the flap lever is moved. The pot is recognized as the Yr axis by FS calibration routine, and is recognized by the BI software. I've been working on this for three nights now with no success. The 'UP' position is zero and the DOWN position is 16,XXX something. Sorry I don't have it open at this moment. When I try to calibrate the second position, flaps 2, the value is 1 for the pre-position and the post-position. The rest of the settings do not register. I checked the pot and even changed it out for another known good pot. These are 10K linear taper pots. Am I doing something wrong?