edsaw34

Wow. Many thanks

WBSIM CESSNA 172 The aircraft has three flap positions 1) FULL (fully extended) 3) 10-degree take off range 2) UP (retracted) Those are necessary when releasing the flaps - when the button is pressed once, the flaps stop at 10 degrees and again at full. And accordingly, when cleaning, it’s the same through an intermediate stop Now it was possible to configure only two positions up and full And also, tell me where in the instructions or resources how to use presets how to add to FSUIP or if they already exist However, there is no way to use the preset in the presentation, or you can assign it to the buttons Thanks a lot, and sorry for a lot of dummy questions.

Sorry again. Please help newcomers. How to set up flaps with three positions - moving up to dawn with different angles. Fsuipc7 recognise flap as buttons in two position (up/down) So I would like to set, for example, up from up and stop in the middle and, after that, push down and control on the lower position and vice versa I didn't find it in the documentation, or maybe it is very technical for me)

Thank you very much. I've deleted lua script and normalised it all. Tnx. Sorry for of topic- with n blank profile in MSFS, how could I setup Honeycomb Bravo Throttle because any reaction in FSUIPC for trust movement

Could you please help newcomer. I made setup based https://forum.simflight.com/topic/91617-a-step-by-step-for-fsuipc7-honeycomb-alpha-yoke-and-msfs2020/#comment-554525 In level flight, a single-engine aircraft is constantly descending (the trimmer has to be turned constantly) and often falls sharply to the left and falls. There is no wind. In the msfs controls settings of the honeycomb alfa everything is centered and everything works correctly Could this setting settings and scirpts make affect or I missed something? many thanks

In level flight, a single-engine aircraft is constantly descending (the trimmer has to be turned constantly) and often falls sharply to the left and falls. There is no wind. In the settings of the steering wheel, everything is centered and everything works correctly Can di this after installing the FSUIPC7 settings and scripts