percy

Thanks, I found my problem I had un checked several message blocks in 3DV5, when I checked them I now get the box to type in the switch function. all is good now. Percy

I have install FSUIPC 6 IN P3DV5, I am unable to get mouse macro to recognize a switch or button with a drop down menu. I have used this in several FSUIPC versions. How do I get this to function correctly ? thanks percy

In P3dv2.5 I was able to use mouse macro but in P3dv3 I am unable to. My question is, is there a way to us mouse macro and then assign to a button in P3dv3, 3.1. Thanks percy.

Hi Pete Thank you for your information. When I used FS9 I calibrated in FS not fsuibc and I just assigned the mapping and all work fine. I tried to do the same with FSX and that is when I was unable to get #3 to move, after reading your info I calibrated in fsuibc and then mapping worked fine as you stated. I have a home built throttle assy and after calibrating with fsuibc the first part of lever movement shows little N1 increase and I had trouble with Engine reverse so in FS I assigned my #2 throttle as #3 calibrated in FS and then mapped in fsuibc so now #1 moves 1,2 and 4 and #3 moves #3 only, all is working fine,. Thank you. percy.

Thanks Pete for your quick reply. I think I can make this clearer as to what is happening, when I map 1-12, 2-34 when I move throttle 1 engines 12 and 4 move, when I move throttle 2 engines 2 and 4 move engines 3 does not move with any throttle input. percy.

I using a two throttle input and need to map for engines 3 and 4 but the #3 engine does not show any movement, 1,2 and 4 are ok. (axis calibration page)I have reloaded FSX, fsuibc4 4.203 and go flight, problem is the same with Air Bus 340, PMDG 747 or FS 747. Number 3 also does not show movement in fsuibc even when using a keyboard. Using Vista 64 and FSX with sp1, FS9 maps ok. Not sure what to check next. Thanks, percy.