Jump to content
The simFlight Network Forums

dandimm

Members
  • Posts

    7
  • Joined

  • Last visited

Everything posted by dandimm

  1. I think I found the culprit, it was the -FastLaunch switch and using the MSFS.bat file to launch FS2020. I think it may have been a permissions issue. I am now just using the standard desktop Steam Fs2020 icon and Run1="C:\Program Files\GoFlight\GFDevFSX.exe" and it is starting and exiting properly.
  2. Yes, but since it is a max of 60 seconds and I don't know how long it will take to pick my flight and load, it was not enough time to delay before I had the cockpit loaded.
  3. Looking for advise and suggestions... I have been using FUSIPC for a very long time and just recently purchase FSUIPC7. I was able to finally get my goflight module rp48 working with FS2020 using the original GFDevFSX.exe. So all the buttons, dials, and lights work and would prefer to use this over the GF64.dll in FSUIPC for the lights to register when I use the buttons. The caveat is GFDevFSX.exe must be ran after you have your flight loaded and in the cockpit. I tried the .ini [Programs] approach, If you load it before using RUN1=READY or in FS2020 exe.xml, it does not work. Any suggestion on how to create an event to fire off the GFDevFSX.exe or use a hot key to load/unload? Is there anything else I can do with the RUN1= in the .ini ? BTW - Great product, keep up the great work and contributions for the sim community! Daniel
  4. Thank you for the response and information. I went to look up the profiles feature in the advanced user guide and found the section on using multiple INI files. That worked great, easy to set up and the best solution for my multiple configurations of FSX. Thanks again.
  5. Hello All - I use FSX with a full registered FSUIPC and would like a way to selectively enable/load FSUIPC using a different desktop icon to start FSX. I currently have 2 icons, one is for my full flight simulator with multiple monitors, rudders, yoke, goflight, etc. The other icon is to run a single monitor and a MS ForceFeedback joystick. Each icon uses a seperate "fsx.cfg" file on the fsx.exe command line. I need to disable/not load fsuipc for the single monitor icon because I get a lot of "interference" (i.e. jittery yoke) from the other USB controls that are enabled and configured thru the FSUIPC. I looked at the dll.xml but it doesn't appear to be a way to have separate dll.xml or exe.xml files for each configuration. What is the best way to does this? Thanks in advance. Dan
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.