I am using a registered version of FSUIPC 4.53 and saitek's throttle quadrant, fsx sp2 with acceleration, windows vista:
i have assigned the spoiler to the z axis in fsx and I have tried all sorts of calibration combinations in fsuipc. currently the Spoiler box on page 6 reads as follows:
Reset (unchecked) Set Set Set
Filter
0 In -16380 0 16380
0 Out (checked) 0 0 [slope](0)
Rev
What is occuring is that the Spoilers arm when I retract them to the 75% mark (from the 100% position fully pushed forward) - this is good. However, as soon as I retract the lever slightly past that point the actually spoilers immediately jump to fully extended. Then I am unable to retract the spoilers as the lever no longer effects anything. I have to use the '/' key to retract the spoilers. I am trying to get the spoilers to slide through a range from 25% to 0% (on the lever) that would effect the spoiler to go from fully retracted to fully extended over that range respectively.
Any help on this matter would be appreciated.
Happy New Year,
Brian
Cincinnati, Ohio USA