mortonrb

Pete I certainly can not explain, as nothing changed from when I submitted the initial issue to when I returned and tested this morning. Thanks for your help. Bill

Peter: Ok, I was able to complete the tests. The order followed was: 1. Start ASN 2. Start FSX 3. Go to KEWR C-80 4. GPS FSC 8.6 5. Disconnect GPS FSC 6. End Flight 7. Close ASN 8. Close FSX This was done for FSUIPC 4.91, 4.934 and 4.934H For some unexplained reasons, all versions of FSUIPC worked as expected. Per your request, I have attached logs from the 3 versions. FSUIPC-LOGS.txt

Peter I am leaving on a business trip this morning, so I will try the update when I return. In my reply, I misstated, when I went back and installed 4.91 it worked. Thanks

I uninstalled version 4.934 and installed version 4.91. Connect to FS function from FS Commander 8.6 is not working.

I had to rebuild my computer, so this is a complete fresh install of Windows 7 x64, FSX Deluxe / Acceleration. FSUIPC 4.934 is installed, UAC is off, all programs set to run as administrator, A/V set to not scan folders where FSX and add-ons installed. FSX is installed on D:\FSX and FSC is installed on C:\FSC. I am running FSC 8.6 Build 20010. When I select Connect to FS, the screen / aircraft position goes to 0/0. This is not a network setup. Below is my FSUIPC Install Log and Current Flight Log. Any ideas would be appreciated. New Text Document.txt

I have the found the problem. My linksys router is causing this. If I connect directly to the cable modem, issue is resolved. Reseting the router to factory defaults does ot work. I have an old router (WRT54G). Will my a new one in the future. Bill

I have the exact same problem with Comcast in NJ. Has there been any resolution? Bill