bunkerjunker

Will do. Thanks Pete.

Raam123, Create a macro for the QW757 and assign the following LVAR to your joystick button for EPR. [Macros] 1=L:thrust=toggle I'm currently working through trying to combat some of the quirks with the QW757, but I have successfully set up the EPR and various other buttons using the above method. The only thing left is to get the altitude and hdg working properly.

The Autopilot normally deals with altitudes in 100's (left mouse click) and 500 (right mouse click), but when using the MCP alt know, it is increasing by 1's. I've tried, but can't create a mouse macro via FSUIPC. The other option was to use VRInsight's key installer, but the main panel has to be open for this to work (and I prefer flying in Virtual cockpit). Any insight you have would be much appreciated! Sterling

So far, this is what I have created in my Macro for the 757. [Macros] 1=L:thrust=toggle 2=L:hdg_sel_dir=cyclic 3=L:app=toggle 4=L:hdg_sel_dir_decr=cyclic 5=L:hdg_sel_dir_incr=toggle 6=L:hdg_clicked=toggle 7=L:hdg_hold=toggle 8=L:alt_hold=toggle 9=L:alt_clicked=toggle 10=L:alt_sel_num_decr=dec 11=L:alt_sel_num_inc=inc 12=L:alt_sel_num=inc 13=L:alt_sel_num=dec

I recently have purchased and installed the VRInsight MCP-Pro and have set it up to run with FSUIPC. I'm learning about how to use LUA's but am frustrated as can be with my altitude knob. I am trying to set up some functions with the QW757. I have set up a macro to read the LVAR's for the altitude selection and have assigned them to the altitude know, but when I use it, my altitudes are increasing in increments of 1 rather than 100 or 500. I've tried various combinations up to this point, but to no avail. Any thoughts/suggestions. Thanks