LeeL

Thanks Pete. I'll try that deleting the ini file. And yes windows recognizes the controllers. Thnx lee

Hi I recently switched over to fsx on a new pc. I installed fsuipc and for the first couple if days everything was fine. But now I can't set my axis. Everything on the set axis page is unclickable I can click reload only when I click reload assignments but that doesn't do anything. and when I put my cursor in the movement or lever boxes nothing happens. It's like it's not recognizing my controllers (Saitek rudder yoke and throttle ) I am in the process of updating my Saitek drivers Any ideas for now? Thanks lee

Hi When I use my Saiek throttle quadrant for more than 1 engine they dont match. There's 1/2 inch difference between the two throttles when the values match. And they don't go out of idle until they hit the 50 mark on the quadrant this really only happens when I use my LDS. In FSUIPC the idle settings in the calibration tab are where they should be. thanks Lee

Hi Pete now I feel a bit stupid :D but thanks for the help and the great program! Lee

Hi I just got my pro flight yoke system earlier this week. Everything has been working fine. But yesterday I went to try and configure a plane using FSUIPC just like I had been doing, but now after I've done the axis assignment page and when I move over to the joystick calibration page and try to configure the aileron movement it beeps every time I hit set. It doesnt happen with any other axis just the aileron. It's happened to two planes now. please help. thanks Lee