Jump to content
The simFlight Network Forums

alexdan

Members
  • Posts

    12
  • Joined

  • Last visited

About alexdan

  • Birthday 01/01/1970

Contact Methods

  • Website URL
    http://

alexdan's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Thanks Pete, will do that. Appreciate the education :) Alex
  2. No problem, I'm expatriate myself and aware of that. No rush anyway. I was using U1 for the Baron and the Goose as well. Odd. I tried the stock Baron quadrant in the DC-3 and it did not work either. However, bringing FSX up again I noted my assignments had disappeared. I corrected these again in U1, and regained control. Next FSX reload had my Mixture settings disappear. Corrected these and OK. Now my settings appear to hold provided I wait approx 10-15secs until PFC appears in the Addon menu..and check my settings are activated. FSUIPC appears immediately. Reloaded my own aircraft and apparently normal with the above proviso. Drive needs Defrag done which may have something to do with delays. Will do later. Strange one - but PFC/FSUIPC would appear to be working properly. Summat amiss with my Quadrant assignments holding, although I have used the same settings for years in Fs9.. I simply check them each time now. Will watch it and advise if it reverts again. Thanks. Alex Best Alex
  3. Old post Jun 29th. The Quadrant is enabled. U1 only has Mixture controls reversed. PFCFSX.ini attached. However it now appears there is nothing wrong with PFC as it works normally on both the Baron and the Goose. I was using the stock DC-3 pending re-installation of my own piston aircraft. Aircraft.cfg and DC-3 airfile are normal and original, as is the panel.cfg. Ideas? Alex PFCFSXINI.zip
  4. Pete Re PFC FSX and Accel problems. New twist. I have FSUIPC and PFC correctly in the addons. I can calibrate the quadrant correctly within PFC, but there is no aircraft actions from the Prop,Throttle,Mixture levers. The Yoke and Rudders, which connect through the quadrant work normally. Flaps and Rudder trim are also OK. FSUIPC4.log, PFCFSX.log, Simconnect.log portions and WinSxS snip attached. Baffled Alex Logs.zip
  5. Accel reinstalled. All back to normal. Thanks for your patience.. Regards Alex
  6. Curiouser and curiouser.. Uninstalled Acceleration with difficulties finally traced to my Virus/firewall program F-secure (aka Shawsecure), now removed. Two x86 folders remain, 60905 and 61242. PFC page still does not load. Have not yet reinstalled Acceleration pending your comments. Logs attached. Have a good weekend meantime... Regards Alex AlexLogs3.zip
  7. These are the simconnect.dll content of each WinSxs Simconnect folder, in that order. Versions 60905, 61355 and 61637. The folders themselves are listed as "60905" "61242" and 61259" if relevant. This is before, and again following, an uninstall and reinstall of Acceleration. Attached are the current logs. I don't know quite where to cut off simconnect.log. I should have mentioned that I am running XP Home with the XP3 update, which may or may not be a factor. FSX was uninstalled and re-installed last month, as was Acceleration. I did a "FSX Repair" with the appearance of this problem. FSX runs apparently normally otherwise. I have the Serial Port PFC Controls. Setup? Perhaps a basic XP problem? Best Alex AlexLogs2.zip
  8. Somedays I find Windows is more of an frustrating enigma than a useful tool :twisted: I note 3 versions of simconnect.dll, 10.0.60985, 10.0.61355.0, and 10.61737.0. Will uninstall and reload Acceleration and get back to you.. Thanks Alex
  9. With Fsuipc4 4.294, PfcFsx 4.305. No change. Logs attached. Fsuipc.log does show a simconnect error. Thanks Alex AlexLogs.zip
  10. Pete I have no PFC menu in FSXA. PfcFsx 4.3.0.0. Fsuipc4 is installed, shows and is normal. Baron Quadrant seems to be working and PfcFsx.log shows "9688 refresh initialization to synchronize switches". But I have no sim access to settings. PfcFsx.dll is present as is .ini file. WinSxS shows all 3 folders with relevant simconnect.dll versions. What have I done :( Dell XPS600 Nvidia 8800, 2gb Ram. Ideas? Thanks Alex
  11. Heck, no need for apologies. Early Days. It will be many weeks before the dust settles on the 1001 interactions we are going to have to sort out with our new MS version... Those of us who do Airfile modifications are already doing a lot of pensive tooth-sucking.. :) Best Alex
  12. Just to substantiate Dennis's report. Same thing here. Registered 3.02, FsMeteo 5.1 patched. Fs2002. Fs2004 next week. Wxp 1200x1600 32bit 512mb ADSL. Still looking at it. Best Alex
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.