fixair

YYYYeeeeeeeeeeessssssssssssssss!!!! I found: sbyte.... That was not simple, but I lay was had!!!!! Good evening everybody ;op FX

Good evening Paul, Thank you again once for your help so precious. I followed your indications as for Offset , and the modifications brought to Timer1 are effective. I confirm you that I leaned on your tuto to make my soft. I me low now for him(it) 0x036E Turn co-ordinator ball position, it seems to me that it is a soft, but I do not take(bring) out there, I crossed(spent) three hours there today. I do not discourage to arrive there one day... Cordially FX

And indeed if, I need help(assistant), I am really a beginner in the coding of software. Thank you for your answer it works. Nevertheless I always stumble over the speed vertical ( 0x02C8 ) and the height. I pedal very very also with my card(map) Arduino, I do not arrive has to have a flow of dated fluids: my servos is jerky, would have you an idea? One thousand excuses to have made a double(doubloon) of this comment while, I had not seen your answer. Thank you again for your help(assistant). For information, one bets of my simulator will be present at the end of the month in 7 ° World Lounge(Show) of the Simulation in Bourget ( LFPB) with the association FAFZONE. Cordially FX ;op

Oup's I am sorry, I admit to have been a little bit impatient and not to have seen the answer of ' Paul, it is promised I shall not redo him(it). FX ;op

Hi, to start with, I am a young French developer which does not speak English a lot, then I use a converter. I work on a Lark 2 which I transform into simulator. It is whom(that) that begins to clamp(stick): I decided to keep(preserve) the instruments in which I put servos or step by step engine. The problem it is the part(party) codes: I do not arrive has to extract the height, the vertical speed and the fuel by serving me as your DLL. It works well for the heading and Eng RPM. These data are sent back(dismissed) on a port(bearing) COM for a card(map) Arduino. Could you say to me of what you think of it? In advance thank you. I invite you has to follow this link or you will see my Alouette 2 : www.mediafx.fr/318 Look almost everywhere and especially Panel.... FX ;op ..../....

Hello Paul, to start with, I am a young French developer which does not speak English a lot, then I use a converter. I work on a Lark 2 which I transform into simulator. It is whom(that) that begins to clamp(stick): I decided to keep(preserve) the instruments in which I put servos or step by step engine. The problem it is the part(party) codes: I do not arrive has to extract the height, the vertical speed and the fuel by serving me as your DLL. It works well for the heading and Eng RPM. These data are sent back(dismissed) on a port(bearing) COM for a card(map) Arduino. Could you say to me of what you think of it? In advance thank you. I invite you has to follow this link or you will see my Alouette 2 : www.mediafx.fr/318 Look almost everywhere and especially Panel.... FX ;op