andremgomes

Sorry, my mistake…. Let me try to explain the situation better. In 2014 I built my motion chair for FSX with three 32 inches monitors. I coded the Arduino board and I used FSUIPC and Link2FS to make it work. With the new FS2020 there is no more Link2FS application (developed by Jimspage) and I’d like to know how to export data for my motion platform(2DOF) from FS2020 to Arduino. Could you help me to find another way to do that ? Any suggestions?

I have been using FSX with my motion platform (arduino) and FSUIPC 4 from a long lime. Now I decided to Install MSFS 2020 and I bought FSUIPC 7 . Could you please tell me where is the interface to set the bound rate and other settings related to output motion setting (pitch, roll, yaw, acceleration, etc) ?

Thanks Thomas, I've downloaded the XPUIPC from that link but I did not find options like sending data to my arduino board. Do you know if it is pissible to send data (like pich roll and yaw) from x-plane 10 to my Arduino Board? Thanking in advance Andre

Dear Support, I´d like to know if there is FSUIPC for x-Plane 10 or X-Plane 11. I´m trying to use my "3DOF STEP MOTOR-ARDUINO MOTION PLATAFORM" with x_Plane-10 . It works well on FSX. Thanking in advance

Dear Support, I'm new on FSUIPC. I bought the FSUIPC (4.60a) and I had to reInstall FSX and FSUIPC. I have two questions... 1) Is it possible to use my SERIAL KEY to activate the FSUIPC again at my new Hard-Drive? 2) Is it possible to upgrade the FSUIPC to newer version using same serial key ? 3) My version 4.60a is registered to ANDRE GOMES at andremgomes@yahoo.com.br but I did wrong and my correct email adress is andremgomes@yahoo.com (not ".br")... Is is possible to correct it? Thanks for your help