markiannarelli

Thanks for the quick response. I will pose a similar type question to Goflight to see what their plans are. Without FSUIPC I think the original MCP had very little compatibilty with the premier add ons. Many Thanks Mark

Hi, Can anyone tell me if the new Goflight MCP Pro is compatible with FSUIPC with regards to using FSUIPC for key mapping the rotaries and buttons etc Thanks in advance Mark

Hi Guys, Yep my problem has now been solved and I have the spoilers working on the axis ok now. It was the sensitivity being set to 0 and the behaviour of the spoilers on the ground Thanks for all the help Mark

Hi Peter, You have solved the fundamental problem which was the FS sensitivity was set to 0 and when I corrected this setting FSUIPC is behaving normally. The assignment in FS was correctly set to spoliers and FSUIPC sees it as a spoiler access. So far so good. The problem I have now now is when I advance the lever just a little bit, the spoilers deploy fully and not as I would expect in sync with how far I advance the lever within the min max range of the axis. Also once deployed they stay deployed and returning the lever back to the min position in the axis does not retract the spoilers. Any ideas would be appreciated Thanks Mark

Hi Peter, Sorry I didn't make myself clear. I have assigned the throttle axis within FS setting the y-notation to be spoilers and have successfully assigned the other throttle to be either throttle controls or flap lever and all are working fine. However with the problem throttle although I can set it to whatever function I want within FS lever when I move between the min to max positions I get no readings at all from within FSUIPC and therefore I can't set the min max values like I had to do with all the other levers. Originally I put this down to FSUIPC not being set up to handle this new device as FSUIPC also didn't recognise the event of pulling the throttle lever back into the dedent position. However with the latest release of FSUIPC I can assign functions to 6 throttle lever dedent buttons. But I still have a thios problem with this one throttle axis that FSUIPC doesn't see when I move the lever. I was beginning to think this was a fault with my throttle, but thought I would post a note here just in case Many thanks Mark

Hi, I recently purchased the above hardware and calibrated it using FSUIPC. I seem to have a problem with one of the throttle lever axis in that FSUIPC does not see the Y-ROTATION axis which is the 5th axis form the left. I had hoped to assign this axis to the spoilers deployment. All the other axis work fine and have been programmed successfully. Is this a problem with FSUIPC or do I have a problem with the actual throttle hardware. Many thanks Mark