RoughLandings

Thanks, that seems to have done the trick. I had downloaded the latest version of FSUIPC but hadn't gotten around to installing it. I also updated my Active Camera and all is good so far.

I have been getting an error the last few days where it states that I have two copies of FSUIPC in my Modules folder. This happens when I start up the simulator. After recieving the message, the sim shuts down. Every time I have gone in and looked and only see one FSUIPC.dll. I am currently running version 3.5.3.0. Any ideas? Thanks, Eric

Ok, first post for me in this forum. I am a long time owner of FSUIPC, but haven't had a whole lot of need to use it much till now. I just purchased the CH Products throttle quadrant and for the most part everything has gone smoothly in setting it up. I have successfully set up all the axis' using the Control Manager and calibrated them in FSUIPC. The only thing that I can't seem to iron out is the throttle calibration. If I set them up to include reversers, I have a dead zone through about the first quarter to third of the lever travel. I am pretty sure that I saw a post somewhere in the forums about this issue earlier when I was going through the initial setup, but I'll be dinged if I can't find it now. So I am sorry if I am bringing up a subject that has already been addressed.