cgodinho

Hello ... That is what i'm going to do. I do the same with the FS hours. But with the fuel .. there are so many fuel thanks. Thank you very much for your support ... Regards

Hello again ... Thanks for your quick reply ... Well, i'm going to think another way to avoid the fuel to be change by the user ... Microsoft is always changing the standard :-) Regards ...

Hello ... I know that it's not possible to disable FSX menus via 32F0 offset. My question is: Is there any other way to do it ? (via another offset, I don't know) Waiting for a reply, Regards Carlos Godinho

Hello, again ... Well , by definition "VLS" is the minimum selectable speed providing appropriate margin to the stall speed. The guidance computer prevents the aircraft from flying below this speed. At least in Airbus aircrafts (in this case A330-200 PSS) This was the light ... Of course : ((194.12639*0.3048)*3600) / 1852 = 115.0167 knots and this is the VS speed (Stall speed) It has the same value in the reference speeds section in aircraft.cfg that I already knew [Reference Speeds] flaps_up_stall_speed = 155//Knots True (KTAS) full_flaps_stall_speed = 115 //Knots True (KTAS) cruise_speed = 460 //Knots True (KTAS) max_mach = 0.82 max_indicated_speed = 350 //Red line (KIAS) My confusion was ft/sec, because i'm used this values in Knots Thank you very much for enlighten me. Best regards Carlos Godinho

Hello I'm trying to get the VLS and the formula is: VLS = VS * 1.3 where VS is the stall speed. I see the offsets 0538, 0540, 0548, 0550 but the explanation in the FSUIPC documentation is not very clear. For instance 0540 - Design speed VS1 (stall speed clean), ft/sec I tried to get some information here in the fórum but don't find any Ok flaps up, but ft/sec ???? that's one of my doubts I check by FSInterrogate the 0538, 0540 offsets (VS0,VS1) and I get this values: VS0 = 194.12639 VS1 = 261.64862 I get VS0 value but without flapsall the other values has no meaning. So can anyone elucidate me about this offsets (the meaning of) , and if it possible to get VLS speed by FSUIPC. Thank's in advance Best regards Carlos Godinho

Hi there…. I have a problem, with the PSS 340, and I don't have the slightest idea what is wrong. In the past everything works well I appreciate same help, please. The problem is this: When I'm near TOC, I put the new altitude on the FCU, let's say 4000 ft, and when the message "deccelerate" appears, I press the altitude knob (left mouse button, managed descend). Well the problem starts here. The plane doesn't descend, and the two brackets indicate allowable airspeed range, don't appear on the PFD, I have to make a op desc. On the MCDU I'm still in cruise mode. At about, let's say, 13000ft the MCDU mode changes to desc mode, and then I can do a managed descend, even the two brackets indicate allowable airspeed range, appear on the PFD. My specs are: FS2002 FSUIPC 3.411 (registered) ActyveSky wxre FsClouds Last week I was reading the FSUIPC manual and I made same changes on the FSUIPC settings. I don't know if I do something wrong. Can anyone give me a possible hint ? Thanks is advance… Regards… Carlos Godinho