Darran Kent
-
Posts
10 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Downloads
Posts posted by Darran Kent
-
-
Hello
I am having a problem when trying to use FSUIPC with the Quality Wings 146. I have set the controls in p3d itself to be ignored and configured my axis to be sent direct to FSUIPC ( i have a Cesna pro flight yoke and throttle set).
All works ok but after about 5 seconds the throttle and yoke stop working. It only appears to happen as soon as i activate the cold and dark state on the FMC .This seems to be the only aircraft I am having problems with. I have also posted on the QW forums.
If I set the yoke and throttles to be controlled from the sim itself they work all the time
Can anyone help me out?
kind regards
Darran
-
Thank you for your replies guys, Silly me was doing it the wrong way round so have it all sorted now :)
-
Hello
I have just bought the full version of FSUIPC and am trying to get it to work with my Saitek Cessna yoke and throttle quadrant. I have disabled joystick within FSX and have sorted the thottle quadrant with no problem but I am having issues with the yoke.
So far I have managed to configure the yoke on the Axis assignment page and it shows Alerons/ elevator etc but I have noticed that when flying it seems a bit too sensitve and the plane wanders on the taxiway. I think i need to set a deadzone within FSUIPC?
I have clicked on the Joystick calibration tab and made sure its set to 1 of 11 main flight controls.
Then I have pressed the set button directly under where it says Alerons direct
I turn my yoke full right and press the set button on max but all i hear is a notification sound and the number does not change. I have also tried setting full left and it does the same thing. Occasionally it works and the number changes for one of the parameters but it never works for all three
Can someone please tell me what I am doing wrong
kind regards
Darran
Yoke stops working with QW 146
in FSUIPC Support Pete Dowson Modules
Posted
I feel a bit of a fool :wacko: I found out the reason why the controls stop working, Its to do with the hydraulic pressure droping to zero when i set the plane to cold and dark. Once I power up APU etc and hydraulics the controls work fine.