cmgam

Hi "dconream" Try these drivers: ftp://ftp.saitek.com/pub/software/full/rs_pfw.exe They are working OK on my Vista 64 system :) . I'm using F2 as "reverser", assigning throttle as Jim Harnes :wink: . "Feathering" propellers, as you, I don't know how to do it :? . Regards cmgam

Hi I need some help to calibrate my Pro Flight Yoke System because, on axis calibration there are no differences between the "min" and "mid" positions. The numbers are the same then, I can't set reverse, props feather and cut off mixture. On CH products I know that there are a "DetentValue" that I must set but on Saitek products I don't know how to do it if the same problems exists. Whith thrust reverse, I "walked around" using F2 key on "buttons + switches" but for prop feather and mixture cut off, I don't know how to do it so the need of help :oops: I have FS9, Vista 64 and the last drivers for Pro flight system. Many thanks in advance Regards cmgam

Hi Just to say that now, after your advices, everything is working. :D Thanks again Regards cmgam

Hi peterhayes and Bob Church I use Control Manager in direct mode; I'll follow your advices and suggestions as soon as I get home. :) Many thanks to you, Regards cmgam

Hi peterhayes and Bob Church I'll follow your advices as soon as I get home. :) Many thanks to you, Regards

Hi I would like to have your help for the following problem with FSuipc and CH quadrant. I have FS2004 (FS9.1) and the lastest version (registred) of your software. After some weeks of inactivity with FS, I resumed my flights to find that my throttle quadrant needs a new setup (before, everything - quadrant, FSUIPC, etc. - works OK). I followed the Jonh Cook tutorial but at not avail. The problem is when I try to assign ANY axis to ANY Joy# of CH quadrant, the FSUIPC cannot record any difference between the detent position of the joy# and the "min" position, i.e., on any axis/joysick, the FSUIPC values - on Axis Assignment and Joystick Calibration modules - are (numeric values can change): MAX position of the joystick: in: 16386 out:16383 Detent position of the joystick: in: -16384 out: -16384 "Min" position of ths joy: the above (same) detent values :shock: ! As I said and you can see, there are no diferences between the 2 lowers positions so I can't calibrate the joystick inside FSUIPC (Reverse/idle). I have joystick disabled on FS; I unistall all the CH products I have (Rudder pedals, yoke and quadrant) and clean the win registry of any CH key and made a new install; I have the quadrant calibrated with CHManager (where the 3 positions are verified and checked); I delete the FSUIPC.ini and created a new but nothing changes :( Any help? :) Many thanks in advance Regards cmgam