zero-7

Q: Is it possible to adjust the sensitivy of the elevator trim (knobs) throu FSUIPC 3.999z8 and where to find instructions? Problem: I'm using a MS Sidewinder joystick with FS2004 and Eaglesoft Citation X V2. Previously I could make very small adjustments in the elevator trim with buttons 3 (-) and 4 (+). After a clean install of windows and FS software the adjustments have changed and are just too big. Giving 2 clicks 'elevator down' makes the aircraft dive down like a stone. Software: MS Fs2004, FSUIPC 3.999z8 (reg), Eaglesoft Citation X V2, Thanks.

I've contacted ES support and they told me the same as Reinhard. So it was me, having some wrong expectations about the behaviour of FADEC. Thanx all for the help

Hello, I'm running into a different problem, which I hope you can help me with. Using: FSUIPC 3.999z8 (FS9) with the Eaglesoft Citation X 2.0 (FS9) on windows 7 x64 system with microsoft sidewinder joystick (single throttle) Problem: After installing and registration of FSUIPC the engines only spool up to a max N1 of 83% at full throttle, so there's hardly enough take-off power... If I delete all FSUIPC files in the 'modules'-folder this problem is not there; engines spooling up to 100% and giving full thrust. In both registered and demo-version i've had the N1=50% idle problem which I've solved by changing the "AxesWrongRange=No" - line to Yes What is causing this problem and what can I do about it? Of course I want to use the full FSUIPC program that's why I purchased a licence but having hardly enough thrust to take-off is dissapointing... Thanx Bert No FSUIPC: Un-/Registered: