Jump to content
The simFlight Network Forums

stalo

Members
  • Posts

    3
  • Joined

  • Last visited

Everything posted by stalo

  1. HI! Pete: I bet you are tired of covering this, but I simply am at a loss! I am sure I am doing something incorrect, but am at a loss as to what. I have installed your program in ME and XP but this is something else. So here goes; I read your installation instructions, which seem easy enough, I turned off the Vista firewall, and this is a new computer and I only have Vista and FSX installed at this time, downloaded your program into a file I call my files, I proceeded to place fsuipc4.exe on the desktop, and installed; the Modules file was created, I opened the file and what you said should be there was, I then opened the installation doc and found it to be in gibberish, went back to the zip file, opened the same doc and it was fine. I turned up FSX and the ADD-ON was there clicked on that and fsupic opened up. The following was observed; there was the version and normal defaults and clear all WX and the check boxes for multi display and single line msgs. Registration spots were blanked out, and I expected that, do to the Admin problem. In summary all the information in the zip seems to be ok! but in the Modules file the information can't be read, and in FSX I would think your page would have had more on it, however I worked on getting a higher position as an administrator, so I might register, but have not accomplished that yet. Any help you could provide would be appreciated. :cry:
  2. Hi! Pete I have finely isolated my problem to the CH managment program. In answer to your question about map and direct mode, CH came out with a managment system, to create a map for there individual requirments for there CH equipment gaming needs. You have the ability to use the map or go to a direct mode. I might add here that your program has been highly touted by the people that have a lot more knowledge than I about that equipment. as a great addition to there program. However I have solved my problem by removing there program, which you don't have to have anyway, and I have just re installed your's. I have not gotten into the button programming yet, however, that will be next. :)
  3. Pete Help!!! I loaded in your FSUIPC 3.48 into FS9. I am using a CH yoke, peddles and throttle with the CH managment program and using MS XP. I am using a shift button to expand the use of the switches. I have trim, using the rocker sw on the LH yoke. In, trying out your button program I have some how gotten the landing lights programed on the Up trim button, and I can not get it to program back. I finally took out your program in desperation, in accordance with your instructions I think! ie: I removed the fsuipc.dll file from the modules folder along with every thing else I though would have an effect, then re installed, and much to my disappointment, the problem still exists. If I put the system into direct mode all is fine, however placing it back into map mode brings the problem back. There must be a file somewhere that has this locked into, and I am by no means computer smart enough to figure it out, so I would appreciate your help before I take out my frustration out on my computer. :?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.