Jump to content
The simFlight Network Forums

burm

Members
  • Posts

    9
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Canada

burm's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Hello I am running p3d 2.5 and having problems with setting up my ch throttle levers with fsuipc. After reinstalling fsuipc 2 of my 6 levers do not work properly in the axis assignment. One of these after pressing rescan will jump from 0 to 16383. The other problem lever when moved rather than -16383 to 16383 goes from 0 to 16383. This ch quad has its own Ch Control Manager and one can calibrate through it which I have done with no problem. Thanks Paul
  2. Perfect! I uninstalled as you suggested and all is well again. Thanks ever so much Pete Paul
  3. I have a number of addon planes,PMDG,Majestic Software, etc. I had my controller unchecked in fsx as I have all configured with fsuipc, everything going well...until. I purchased the flight1 kingair. I was having problems with the throttles so I reverted back to fsx control but still could not get them working so I parked this plane for now. I unchecked controller in fsx but have new problems. Only 4 lever out of 6 are working correctly on my CH throttle quad. These 2 levers when pushed slightly forward in fsuipc axis and calibration jump from the lowest minus number to the highest + number, therefore causing the fsx plane lever to jump from idle to maximum. I tried deleting the fsuipc.ini and no improvement. I recalibrated using the ch control manager and they seem to be fine. Would appreciate some help. thanks Paul
  4. [MOVED FROM FAQ subforum to Support Forum, so it can be answered] I just got my computer back from the shop and my Saitek yoke works like it did before except for the hatswitch. I have fs controls disabled in FSX and use only FSUIPC 4.929. I read the page 33 in the manual as I had forgotten how I had the hatswitch setup before. I tried to set pan view in axis assignment and it still does not work. Do I set it using the left or right side of the axis assignment page? Do I need to delete something in the fsuipc.ini file? thanks Paul
  5. Hi Pete Thanks for the reply. I will look into the Logiteck functions. Paul
  6. I have a Logitech G400s mouse which has two extra buttons on the left side. I would like to assign these buttons to zoom in and out using fsuipc. I tried using the buttons switches tab and then the key press tab but when I press the buttons fsuipc does not recognize it. I use fsuipc reg version for all my controls with fsx assignments disabled. How can I do this? Thanks Paul
  7. What do you mean by the saitek configuration.
  8. I am trying to setup my saitek yoke, throttle quad, pedals and trim wheel. After an attempt I find my throttle when moved slightly forward my engines jump about half the full rpm. Upon checking fsuipc calibration for the throttles, at idle it = -16383. When starting to move the throttle lever the numbers jump from -16383 to 0 and then increasing through the positive numbers to +16383. This does not go through the minus number increasing to zero. How do I correct this? Thanks Paul
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.