gporta

Hello! I'm using a Saitek yoke and throttle quadrant, all configured through FSUIPC (version 4). On the throttle quadrant, the reverse part of the throttle acts as a button rather than an axis. So I had this reverse "button" mapped to slowly decrease throttle, which would put the power into reverse, the only way to do it as far as I know. In the B200, 25-100% of the quadrant is used for throttle, 0-25% is the beta range. I originally had a problem where when I pulled the throttle down to 0% to go start going into reverse, it would flip back up to 25%. I solved this problem by reading this thread: http://forum.simflight.com/topic/77590-flight1-king-air-b200-reverse-thrust-setup/ My reverse is set up so once it is released, it would engage the flight control "throttle cut". On a normal aircraft this would return the throttle to 0%, but on the B200 it flips it up to 25% (which is idle). However, if I use a control like "throttle 10" it will flip it up to 10% instead, which is inside the beta range. My question is, how can I set up "throttle set" to set the throttle to 0% or 1%? I put 0 or 1 in the parameter field and it doesn't make a difference, a location on the axis does nothing either. Any suggestions?