Rich_Cooke

Many Thanks for the reply Pete. My LUA programming skills are just at beginner level but I'll do some research on programming a Lua plug-in for it. Rich Cooke

Hi - I have used my VRInsight 737 flawlessly with the iFly 737 but I am just wondering if anyone knows if it is possible to access the buttons on the VRInsight 737 OVHD with FSUIPC (FSX Steam Edition/Windows 10) so I can use it with other aircraft. I have followed the Appendix to the FSUIPC User Guide on VRInsight Panels. MY 737 OVHD was on Com5. I have the Eterlogic Virtual Serial Port software and made a device pair of Com8, Com9 and I run that on PC startup. I have put the appropriate entries in my FSUIPC ini file [VRInsight] 1=COM5, COM9 When I launch the VRInsight software my OVHD now shows as on Com 9 But I cannot get further than that. I launch fsx-se, select a flight then open the VRInsight software.There are only four options in the VRInsight 737 OVHD dropdown to launch the panel. One each for the Ifly and the PMDG 737. Selecting those causes a file not found error (Not surprising as I don't have them installed on this PC.) The remaining options option are 737 OVHD Test and PMDG 777 Test. I have tried selecting those in turn but nothing shows up in FSUIPC when I flick a switch on the Overhead. I have just about reached the conclusion that because the 737 OVHD seems to need a specific .dll module to interface with specific FSX aircraft am not going to be able to access its buttons through FSUIPC...unless anyone knows to the contrary. Rich Cooke

I don't know if anyone can help but I am having trouble which SimConnect Variable/FSUIPC Offset is behind the operation of the port and starboard Generator Undervolt lights on the Flight1 Britten Norman Islander. I am trying to work out which values illuminate/extinguish these lights so I can emulate that in my panel set up. I'm sure this is down to my lack of knowledge of FSUIPC logging. It looks like it should be "2880/2890 8 Generator alternator 1/2 bus voltage" for both engines but if I monitor these it stays at zero throughout during the start up process. Hope someone can help me sort this out. Thanks Rich Cooke