Jump to content
The simFlight Network Forums

Search the Community

Showing results for tags '10k'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Product Support Forums
    • FSUIPC Support Pete Dowson Modules
    • MyTraffic Support Forum
    • FeelThere Support Forums
    • FS Commander Support Forum
    • Flying W Simulation
    • AConstable Traffic Sounds Support Forum
    • Fabio Merlo Products Support Forum
    • Elite-Air Studio Support Forum
    • Nikola Jovanovic Support Forum
    • Intrasystems Support Forum
    • Taburet & DanVFR Support Forum
    • Environ Scenery
  • simFlight DE
  • FS MAGAZIN (DE)
  • simRussia

Categories

There are no results to display.


Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi Pete, First ever post on a forum for help! I have the BU0836X and BBI-32, both from Leo Bodnar. I also ordered a 10k pot (Leo Bodnar) and rotary switch and have a rotary encoder on order. I am building my own multi-panel to use with the MJ Dash 8 Q400. I am familiar with your software at a semi basic level i.e. I have all my control surfaces reverse thrusters working perfectly, thanks to your excellent software and guides :-) The Issue: I am using a 10k potentiometer connected to the BUX board via the analouge (Dial) input to control the overhead panel brightness knob using a mouse macro which I have working using the guide, the problem I have is that I can't get the knob in the virtual cockpit to turn through the full 100% of travel. I tried using the full 10 ranges for action available in the axis assignment with each assignment being a short range -- when testing the travel on the potentiometer I realised that Majestic have the rotary knob as 32 seperate switched positions, each increment turning the dial 3% of the full travel, so when I turn the potentiometer clockwise the most travel I can achieve on the virtual knob is 50%. (This would be 25%, however I have doubled this with a within range and then exiting range command in the axis assignment). So, I have 32 positions in total. But I only have 10 commands to switch positions. The 10 can be doubled to 20 using the "range exited control sent" checkbox -- but what about the remaining 12 positions? I should also point out I have not yet started on the brightness down, just to keep it as simple as possible for now :-\ Given these issues I am wondering if it will even be possible to acheive the full 100% of travel (Up & Down) with a potentiometre. Should I use a 360 Deg rotary encoder to do the job, or if there is an alternative approach using the potentiometer?? Any expertise would be greatly appreciated!! Many Thanks in advance Robert
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.