Search the Community
Showing results for tags 'setup'.
Found 2 results
I have recently been trying to setup my Saitek Throttle and seem to be having some problems. I have Assigned to axis' on my throttle to a throttle each aka. Axis Y for Throttle 1 and Axis Z for Throttle 2. I assigned both in the Axis assignment section of FSUIPC and then pressed 'Set' for both Throttle 1 and 2 in the Calibration section but when I went into the VC I had a problem. I tried moving both at the same time and the first thing I noticed was that Throttle 1 jumped straight to about 50% even though I only pushed it forward slightly on my Saitek Throttle. Throttle number 2 seemed fine, when I move it a slight bit it only moves a slight bit in the simulator so Throttle 1 is the only one I am having problems with. I am still fairly new to FSUIPC so still trying to get the hang of it. My FSUIPC.ini file - http://pastebin.com/RGBuYGX0 Thanks, Robbie
Pete- Per your request................ Thanks for your patience and assistance (as usual). After ALL of this- my solution for the SERIAL PFC HARDWARE & THE PMDG NGX (using PFCFSX.dll v4.40 & FSUIPC v 4.859s) is the following- I put this here in the hopes of saving some other poor soul from the frustration encountered- DO NOT CALIBRATE THROTTLES OR REVERSER AXIS IN FSUIPC USE PFCFSX.dll for throttles and reversers- calibrate those axis in PFCFSX.dll ONLY FLY AND ENJOY THE NGX :) Best- C