RipPipPip Posted March 6, 2006 Report Share Posted March 6, 2006 Hi! Sorry for bother you but the following problem looks like to be the last in my "photoscenery factory": I prepared 4 photos of an interesting area: NW and SW are BMPs with ALPHA (because of water) and NE and SE are just plain BMPs. I put them through resample separately (because my PC can process no more then roughly 500 km2 and there is about 1400 km2 to cover). So, the problem are these strips around each area - original BMPs are aligned pixel to pixel each one to another ... What trick should I do not to have these water stripes? This is Sahara not a channeled Netherlands, anyway :) I remember same problem with aligning meshes but forgot the solution ... Link to comment Share on other sites More sharing options...
RipPipPip Posted March 7, 2006 Author Report Share Posted March 7, 2006 Hi again guys, just FYI here's the answer: http://forums.avsim.net/dcboard.php?az=&mode=full Link to comment Share on other sites More sharing options...
Recommended Posts