Jump to content

Engine Start Lever


Recommended Posts

Hello,

because this is my first post in this forum, I want to start with a big THANK YOU Pete, for your wonderfull FSUIPC and WideFS.

Here my question:

I'm using the CH Yoke, CH Pedals and the CH Throttle. Also I'm using the PM software. For the CH Throttle I have assigned one axis for the spoiler, two for the engine throttles and one for the Flaps. Now I want assign the two other axis for the Engine Start Levers. But I can't find it in the drop-down.

Am I blind or are they renamed, or isn't it possible to assign axis for the Engine Start Levers?

Best Regards

Norbert

Link to comment
Share on other sites

Hello Thomas,

first also a big THANK YOU to you, for your work, like the PM air files for the PMDG.

Yes, I was looking for the "Idle / Cutoff". I have now assigned the Mixture-Axis 1 and 2 and it works, BUT only phisikaly. That means, I can move the levers.

Normaly I have moved the Lever at about 18% N2 from Cutoff to Idle. But after I have moved them now from Cutoff to Idle, some seconds later they moved by himself to Cutoff. So I never can start the engines now.

Do you have a nother idea for me?

Thank you

Norbert

Link to comment
Share on other sites

yes it works now, but only without the PMSystems. If I'm using PMSystems I have to klick on the Engine Start Levers on the screen to get the Engines to work. Do you know the solution?

Ah .. with pmSystems you have to have everything else right too. Evidently you haven't. Do you have the handbook for the aircraft? That's what I use.

Please post questions about pmsystems to the PM webgroup site. There are folks there who will help. it sounds like you need to learn more about the overhead. ;-)

Regards,

Pete

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.