yvon Posted December 30, 2007 Report Share Posted December 30, 2007 Hello, Just wondering wether fS ( 2004 ) sensitivity has to be set to null while using fsuipc direct to fs or is that sensitivity only handled by curve response setting ? Bests regards , Yvon Link to comment Share on other sites More sharing options...
Pete Dowson Posted December 31, 2007 Report Share Posted December 31, 2007 Just wondering wether fS ( 2004 ) sensitivity has to be set to null while using fsuipc direct to fs or is that sensitivity only handled by curve response setting ? I've never actually tested this, but I think FS's sensitivity and null zone settings only apply to axes assigned in FS. Certainly, If you assign in FSUIPC for direct calibration in FSUIPC they are irrelevant. Of course you shouldn't have the same axes assigned in both FS and FSUIPC, or you'll get conflicting actions when you use them. If you find that FS insists on re-assigning axes every time you reload it, even though you did delete all the assignments, you could try setting all the sensitivities to minimum (full left) -- they shouldn't interfere then. Regards Pete Link to comment Share on other sites More sharing options...
yvon Posted December 31, 2007 Author Report Share Posted December 31, 2007 Hello Pete, Thank you for your interesting advice about sensitivity i will now test all this . Best regards, Yvon Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now