Jump to content
The simFlight Network Forums

Recommended Posts

My first post:  I have FSUIPC4 4.939 (registered) running in P3D 2.5; Saitek yoke, throttle, rudder, and trim fully controlled by FSUIPC (and thank you for that!).  My problem exists with or without TRrackIr 5 or ASN add on programs running.

 

When I start P3D for the first time after a PC boot everything works perfectly until I adjust the trim control; once the trim is used I lose all control inputs and FSUIPC not only quits working but is frozen to the point that the program cannot even be modified, nothing can be selected.  However, if I exit P3D and restart, everything works perfectly again including the trim.  The only difference in the FSUIPC4.log is the following entry in the first run:

 

1900890 ***** HID USB device reconnected: re-initializing FSUIPC connections

 

The line is gone from the log on the next run. I have changed USB ports and tried resetting the trim settings (after the first run) and the problem persists.  I look forward to any suggestions.

Link to post
Share on other sites

My first post:  I have FSUIPC4 4.939 (registered) running in P3D 2.5; Saitek yoke, throttle, rudder, and trim fully controlled by FSUIPC (and thank you for that!).  My problem exists with or without TRrackIr 5 or ASN add on programs running.

 

When I start P3D for the first time after a PC boot everything works perfectly until I adjust the trim control; once the trim is used I lose all control inputs and FSUIPC not only quits working but is frozen to the point that the program cannot even be modified, nothing can be selected.  However, if I exit P3D and restart, everything works perfectly again including the trim.  The only difference in the FSUIPC4.log is the following entry in the first run:

 

1900890 ***** HID USB device reconnected: re-initializing FSUIPC connections

 

The line is gone from the log on the next run. I have changed USB ports and tried resetting the trim settings (after the first run) and the problem persists.  I look forward to any suggestions.

Sounds like a bad joystick driver. There's no way a simple reconnection will cause FSUIPC to hang and if FSUIPC hangs so does P3D, so you wouldn't be able to exit.

Pete

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.