Which Command for "Cycle Views"?

[LTCSZ]

Hi: I am reprogramming my keyboard commands with FSUIPC and this is driving me crazy...Which command should I be using for "cycle views"?...The default in P3D is the "S" key, but I cannot find the equivelent command in the FSUIPC menu...Thanks a lot...

 

Stevwe

KGCK

[Pete Dowson]

Hi: I am reprogramming my keyboard commands with FSUIPC and this is driving me crazy...Which command should I be using for "cycle views"?...The default in P3D is the "S" key, but I cannot find the equivelent command in the FSUIPC menu...Thanks a lot...

 

FSUIPC's list is actually made from the internal list in P3D, contained in their "Controls.dll". FSUIPC doesn't invent them. The names can be obscure at times. In this case they are really not particularly obscure. There is a document listing them all provided in your FSUIPC Documents subfolder, in the Modules subfolder -- as pointed out in the Installation document. If you search this list for "View" you'd find, among many, others these

 

NEXT VIEW

PREV VIEW

 

NEXT SUB_VIEW

PREV SUB_VIEW

 

I think one pair is usually assigned to A/Shift A and the other to S/Shift S, but I'm not sure which is which offhand as I never use the keyboard.

 

In general, if you want to find precisely which FS control is being used for any action, button or switch, just go to FSUIPC's logging tab and enable Event logging. Then when you use it it will be logged with both number and name. To make it easier you can even select the "console log". Then, if you (temporarily) run P3D in Windowed mode, you can view the Log file in real time in its own Window.

 

Pete

[LTCSZ]

Thank you very much for your assistance...Guess I was guilty of not reading the manual close enough!

 

Steve

KGCK