Fixing problems with 50% (or digital on/off) action with Saitek levers

[pablojc]

Hello everyone, this is my second post in this prestigious forum.

I have the same problem with one of the levers (center) in my throttle quadrant Saitek. When I do the calibration test in the windows panel, the three levers mark the range completely normal without problem.

In FSX calibration module, the the medium lever that I use for the espoiler (axis X) does not move in any sense. The other two levers move complete.

I have already tried everything recommended in this forum (and others) but the problem persists.

I appreciate any advice or suggestion what could be the cause of the problem.

Thanks in advance
Pablo from Caracas

pd: Excuse my English.

Edited April 14, 2017 by pablojc

[Pete Dowson]

I've moved this from the FAQ subforum, which is for refernce subjects. Your problem is NOT the same problem as that which the FAQ thread was dealing with -- you have a strange problem with one out of three levers on the same device.

Since this is not about FSUIPC at all, but only FSX, I really suggest that you re-post in the relevant AVSIM Forum. I suspect you might get more response there. I cannot imagine what is happening, though the first test you should do is see if it works in FSX when assigned to another control. It may be to do with the aircraft you are using.

Pete