Jump to content
The simFlight Network Forums

Fly Flight Plan (solved by user)

Recommended Posts

Hi all

I have bought and installed FSC 10 working fine

At present i have an issue  with the Fly Flightplan

I generate a Route via Route Finder and add it to the FSC10 no problem there, I am flying a PMDG 737-800 with my FMC programed,

As soon as my aircraft departs from the given airport the FSC10 tries to take over of my aircraft and make the aircraft fly the flight plan not the route i have programed on my FMC.

I have checked my setting and the GPS on the FSC10 and they are switched off.

here you have a picture screen shot of FSC10 with the route and you can see that it shows the fly fight plan ring.

I have attached and image of FSC10 and the GPS.


I would appreciate your help

fly flight plan2.jpg

fly flight plan.jpg

Share this post

Link to post
Share on other sites


Regardless of the fact thats your screenshots are too small (even if I use a magnifying glass)
and does not explain anything about the different route...
... the FlightSim Commander is technically not able to control the PMDG 737 via autopilot.  . 

The reason for this is, that the PMDG has its own autopilot and is controlled by the entries in the FMC.

There must be significant differences betweenboth flight plan and/ or routes
of the FlightSim Commander and your programming of the FMS.

To investigate your problem I need 3 flight plans.
1. one original flight plan of the FlightSim Commander in FSC format and and one in the PMDG format.
2. and further the PMDG flight plan you programmed and saved in the FMC.

You can publish the flight plans within your next post or send them to my e-mail address.
You can find the address on this website: www.fscommander.com  




Share this post

Link to post
Share on other sites

Hi again

The thing is that when the AI Aircraft in the FSC10 gets close to the next way point the RING changes to the next way point,

this make my flight sim want to fly this way point, infarct wiles i am on the flight sim which is running on a different screen of the FSC10

it simply losses sound as the FSC10 takes over, this should not be happening.

to get back to my FSX i have to click on the FSX Main screen to regain control or even sound.


Why dose the FSC10 takes over my Flight sim?

Again this only happens when there is a route in the Commander.


Share this post

Link to post
Share on other sites
This topic is now closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.