Jump to content
The simFlight Network Forums
elsmoko

FSC v10.0.5 Intro pop-up persistance issue (solved by user)

Recommended Posts

To all,

  I use FS Commander Version 10.0.5 with FSX Acceleration in Win 7-64.

FSC starts and runs as normal;  however the small intro window is

remaining open and insists on being “on top” on my main monitor screen

(I use two monitors).

  Is there some setting I can make, either in the FSC UI or in a  .ini file

perhaps,  to force the FSC Intro window to close after FSC startup ?  I looked

through the FSC.ini file for a line such as “ Show_Intro=0 “ (or 1) but I

found nothing similar to that.

Thank you,

Ken Boardman

Share this post


Link to post
Share on other sites

Hello Ken,

I cannot verify your problem.
None of the over 12,000 posts here in the forum report this problem.
The intro window cannot be switched off by a parameter during the loading process.

Best regards,

Volker

 

Share this post


Link to post
Share on other sites

Thank you for responding Volker. I may try a reinstall of FSC.  Which folders would you recommend backing up prior to reinstalling ?  I have 3

in mind,  but I'll wait for your recommendation.

Best regards,

Ken

Share this post


Link to post
Share on other sites

Hello Ken,

a programmer around me, to whom I explained your problem, explained the following phenomenon to me.
In very rare cases it can happen, if another program is started before or during the start of FSCommander,
this other program occupies the window of FSCommander and does not release it again.

Before uninstalling, I would try to start FSCommander as a first and only program before or after all other programs you need while flying.

Quote

Which folders would you recommend backing up prior to reinstalling ?  I have 3 in mind,  but I'll wait for your recommendation.

As a SimMarket customer, (not required for Aerosoft customers).
make sure to save the Register.fsc file or since the file Register.fsc can not be replaced in case of loss,

I recommend you to print the data of this file.
In the MENU of the FlightSim Commander you can under About -> Register print the data of the file Register.fsc.

I also recommend backing up the following files:

\fsccolor.ini 
\fsc.ini 
\User\Blackbox 
User\Logbook.fsc 
User\aircraft.fsc 
User\BuddyIvao.fsc 
User\BuddyVatsim.fsc 
\Flightplan\FSC 
\Database\UserWP.txt 
\Database\UserObj.txt 

Best regards,

Volker

 

Share this post


Link to post
Share on other sites

Thanks so much Volker.  No need tlo back up the files now ~:)  But I'll save the information in case I need it later. 

I have been starting FSC from a batch file which also starts other utilities which I had been closing before

FSC had finished starting.  When I let FSC finish starting and THEN close the utilities the FSC Intro pop-up

vanishes.  You "hit the nail right on the head" and I sure appreciate it..

Best to you and your programmer,

Ken

 

Share this post


Link to post
Share on other sites

Hello Ken,

I am happy to hear that the tip was the solution.
I will tell my friend that he is "a bright, smart head".
Especially when the sun shines on him.

Take care,

Volker

 

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.