Throttle Controls Swapping

[cr2130]

Hello, I am new to using FSUIPC but after years of failing to get various controls to work I thought i'd give this  try and it worked, well for one day anyway. I have 2 Logitech Pro flight Throttles which I use (or try to) in FSX. I set up the lever and button commands in FSUIPC and it worked brilliantly. I have gone to load the same Aircraft again today and I have found that the controls have all swapped around. What were assigned to the quadrant on the Left has now been moved to the quadrant on the Right and the same with the Right moving to the Left. I had shut down my system in between the flights as one was the first day and one was today, but surly this shouldn't cause this ? Any help anyone can offer would be very appreciated. Thanks !

[John Dowson]

46 minutes ago, cr2130 said:

I had shut down my system in between the flights as one was the first day and one was today, but surly this shouldn't cause this ?

No, this shouldn't cause your issue. However, if you have re-connected your USB devices in any way, the joystick Ids could have changed if you are not using the 'JoyLetters' facility (see User manual for details). You can try activating this by setting
    AutoAssignLetters=Yes
in the [JoyNames] section of your ini. Then start the sim. If the quadrants are still the wrong way around, you can close the sim, open the ini and swap the assigned letters around (for both entries, descriptive and GUID), save the ini and then restart the sim to check.

[cr2130]

On 5/14/2020 at 12:30 PM, John Dowson said:

No, this shouldn't cause your issue. However, if you have re-connected your USB devices in any way, the joystick Ids could have changed if you are not using the 'JoyLetters' facility (see User manual for details). You can try activating this by setting
    AutoAssignLetters=Yes
in the [JoyNames] section of your ini. Then start the sim. If the quadrants are still the wrong way around, you can close the sim, open the ini and swap the assigned letters around (for both entries, descriptive and GUID), save the ini and then restart the sim to check.

Thanks for the help this seems to have done the trick !