MCT Posted May 15, 2020 Report Share Posted May 15, 2020 Hi guys, Two questions: 1: At the rotation point, when I start pulling my joystick back, to use the elevators, the thrust levers go automatically back to idle? (I set thrust by putting the levers up to 40%, and then autothrust does the rest without my further interactions) 2: The E190V3 is much to sensitive to my Joystick inputs. Manual landing is due to that NOT possible :-( The P3DV4.5 settings to the joystick are all the same to my airplanes and with others, I dont´t have this problems. Is there a setting within the E190V3 SP1 software to make it not that sensitive for inputs? Greetings Manfred Link to comment Share on other sites More sharing options...
scoobflight Posted May 15, 2020 Report Share Posted May 15, 2020 1 hour ago, MCT said: I set thrust by putting the levers up to 40%, Set throttles full forward. See details manual page 61. 1 hour ago, MCT said: make it not that sensitive for inputs No. You are the first to report such a problem so I suggest you look at a local setting that may be causing excessive yoke response. Link to comment Share on other sites More sharing options...
MCT Posted May 15, 2020 Author Report Share Posted May 15, 2020 Thx a lot for your quick answer! I will try part 1 and have a deeper look into part 2! Link to comment Share on other sites More sharing options...
Matty260191 Posted May 15, 2020 Report Share Posted May 15, 2020 quick question have you presses the toga button to actually be in takeoff mode. I used to take off like you describe with lnav and vnav but didn't realize toga should be pressed to get the takeoff initialized on the PFD Link to comment Share on other sites More sharing options...
MCT Posted May 16, 2020 Author Report Share Posted May 16, 2020 I pushed the puttons at the rear of the Throttles to perform take off! Link to comment Share on other sites More sharing options...
Matty260191 Posted May 16, 2020 Report Share Posted May 16, 2020 did it say TO in the PFD at the top? Link to comment Share on other sites More sharing options...
MCT Posted May 17, 2020 Author Report Share Posted May 17, 2020 Yap! it does! So, in my opinion nothing seems wrong?! 🙂 Link to comment Share on other sites More sharing options...
scoobflight Posted May 17, 2020 Report Share Posted May 17, 2020 20 hours ago, MCT said: nothing seems wrong?! 🙂 So ... Using my and Matty's suggestions the issue is resolved? You comment is unclear. Link to comment Share on other sites More sharing options...
Matty260191 Posted May 18, 2020 Report Share Posted May 18, 2020 are you sure you filled out everything in the FMC performance correctly and vspeeds? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now